KSZ8091RNB-EVAL開發板套件編程器的評估演示板及套件規格書PDF中文資料

General Description

The KSZ8091 is a single-supply 10Base-T/100Base-TX Ethernet physical-layer transceiver for transmission and reception of data over standard CAT-5 unshielded twisted pair (UTP) cable.

The KSZ8091 is a highly-integrated PHY solution. It reduces board cost and simplifies board layout by using on-chip termination resistors for the differential pairs, by integrating a low-noise regulator to supply the 1.2V core, and by offering a flexible 1.8/2.5/3.3V digital I/O interface.

The KSZ8091MNX offers the Media Independent Interface (MII) and the KSZ8091RNB offers the Reduced Media Independent Interface (RMII) for direct connection with MII/RMII-compliant Ethernet MAC processors and switches.

Energy Efficient Ethernet (EEE) provides further power saving during idle traffic periods and Wake-on-LAN (WOL) provides a mechanism for the KSZ8091 to wake up a system that is in standby power mode.

The KSZ8091 provides diagnostic features to facilitate system bring-up and debugging in production testing and in product deployment. Parametric NAND tree support enables fault detection between KSZ8091 I/Os and the board. Micrel LinkMD? TDR-based cable diagnostics identify faulty copper cabling.

The KSZ8091MNX and KSZ8091RNB are available in 32-pin, lead-free QFN packages (see “Ordering Information”).

Datasheets and support documentation are available on Micrel’s web site at: www.micrel.com.

Features

? Single-chip 10Base-T/100Base-TX IEEE 802.3 compliant Ethernet transceiver

? MII interface support (KSZ8091MNX)

? RMII v1.2 interface support with a 50MHz reference clock output to MAC, and an option to input a 50MHz reference clock (KSZ8091RNB)

? Back-to-back mode support for a 100Mbps copper repeater

? MDC/MDIO management interface for PHY register configuration

? Programmable interrupt output

? LED outputs for link and activity status indication, plus speed indication for KSZ8091RNB

? On-chip termination resistors for the differential pairs

? Baseline wander correction

? HP Auto MDI/MDI-X to reliably detect and correct straight-through and crossover cable connections with disable and enable option

? Auto-negotiation to automatically select the highest link-up speed (10/100Mbps) and duplex (half/full)

? Energy Efficient Ethernet (EEE) support with low-power idle (LPI) mode and clock stoppage (MII version only) for 100Base-TX and transmit amplitude reduction with 10Base-Te option

? Wake-on-LAN (WOL) support with either magic packet, link status change, or robust custom-packet detection