M7049-103中文資料ENERCON數據手冊PDF規格書

Main Features

? 900W/30 sec. Over-load capability

? Up to 8 Modules can be paralleled (current-share), supporting up to 6KW load (7.2KW for 30 seconds).

? Built-in EMI Input & Output Filters

? 30 to 200 VDC input voltage range, compatible with the rectified output of most PMG’s.

? Crowbar over voltage protection

? Overload, Over-voltage, and Over-temp protections

? No external capacitors required

? No minimum load required

? Base-plate cooled (by external heatsink)

? On/Off input and BIT output.

? Remote Sense lines.

? Upon request, the output voltage can be factory trimmed above or below 28Vdc.

General Description

M7049-103 is a 750W high efficiency switching regulator, that when fed from the rectified output of a 3-phase Permanent Magnet Generator (PMG), will provides a well-regulated, filtered, and protected 28VDC Output. The M7049-103 is designed for parallel current-sharing operation, allowing the user to parallel up to eight M7049-103 units and supports up to 6KW (7.2KW for 30 sec.). For typical application see Figure 1. Note: P/N M7049-103 is identical to M7049-102 but without the pre-assembled “Piggyback” I/O filter board that provides additional filtering and convenient Bus-bars terminals. The M7049-103 is intended for users who cannot accommodate the additional 16mm that the I/O filter board adds to the 42mm depth of the Module.