PI90LV180W集成電路（IC）的驅(qū)動(dòng)器接收器收發(fā)器規(guī)格書PDF中文資料

Product Description

The PI90LV179, PI90LV180, PI90LV050, and PI90LV051 are differential line drivers and receivers (transceivers) that are compliant with the IEEE 1596.3 SCI and ANSI/TIA/EIA-644 LVDS standards. These devices use low-voltage differential signaling (LVDS) to achieve data rates in excess of 660 Mbps while being less susceptible to noise than single-ended transmission.

The drivers translate a low-voltage TTL/CMOS input into a low voltage (350mV typical) differential output signal. The receivers translate a differential 350mV input signal to a 3V CMOS output level. The driver section can be independently set to a power-down and high-impedance output mode with the DEN pin (active HIGH). The receiver section is controlled by the REN* pin (active LOW).

Product Features

? Signaling Rates >660 Mbps (330 MHz)

? Single 3.3V Power Supply Design

? Driver:

— ±350mV Differential Swing into a 100-Ohm load

— Propogation Delay of 1.5ns Typ.

— Low Voltage TTL (LVTTL) Inputs are 5V Tolerant

— Driver is High Impedance when Disabled or VCC <1.5V

? Receiver:

— Accepts ±50mV (min.) Differential Swing with up to 2.0V

ground potential difference

— Propagation Delay of 3.3ns Typ.

— Low Voltage TTL (LVTTL) Outputs

— Open, Short, and Terminated Fail Safe

? Industrial Temperature Operating Range: –40°C to 85°C

? Package Options: SOIC, TSSOP, MSOP

? Meets or Exceeds IEEE 1596.3 SCI Standard

? Meets or Exceeds ANSI/TIA/EIA-644 LVDS Standard

? Bus-Terminal ESD exceeds 12kV

Applications

Applications include point-to-point and multidrop baseband data transmission over a controlled impedance media of approximately 100 ohms. These include intra-system connections via printed circuit board traces or cables, hubs and routers for data communications; PBXs, switches, repeaters and base stations for telecommunications and other applications such as digital cameras, printers and copiers.