SMJ27C010A中文資料AUSTIN數(shù)據(jù)手冊(cè)PDF規(guī)格書

GENERAL DESCRIPTION

The SMJ27C010A series are 131072 by 8-bit (1048576-bit), ultaviolet (UV) light erasable, electrically programmable read-only memories (EPROMs).

These devices are fabricated using power-saving CMOS technology for high speed and simple interface with MOS and bipolar circuits. All inputs (including program data inputs) can be driven by Series 54 TTL circuits without the use of external pullup resistors. Each output can drive one Series 54 TTL circuit without external resistors.

The SMJ27C010A EPROM is offered in a ceramic dual-in-line package (J suffix) designed for insertion in mounting-hole rows on 15.2mm (600mil) centers.

These EPROMs operate from a single 5V supply (in the read mode), and therefore, are ideal for use in microprocessor-based systems. One other 13V supply is needed for programming. All programming signals are TTL level. These devices are programmable using the SNAP! Pulse programming algorithm. The SNAP! Pulse programming algorithm uses a VPP of 13V and a VCC of 6.5V for a nominal programming time of thirteen seconds. For programming outside the system, existing EPROM programmers can be used. Locations can be programmed singly, in blocks, or at random.

FEATURES

? Organized 131,072 x 8

? Single +5V ±10 power supply

? Operationally compatible with existing megabit EPROMs

? Industry standard 32-pin ceramic dual-in-line package

? All inputs/outputs fully TTL compatible

? 8-bit output for use in microprocessor-based systems

? Very high-speed SNAP! Pulse Programming

? Power-saving CMOS technology

? 3-state output buffers

? 400mV minimum DC noise immunity with standard TTL loads

? Latchup immunity of 250 mA on all input and output pins

? No pullup resistors required

? Low power dissipation (Vcc = 5.5V)

Active - 165 mW Worst Case

Standby - 0.55 mW Worst Case (CMOS-input levels)